• Categories:Industry news
• Author:
• Origin:
• Time of issue:2022-07-26 16:28
• Views:

(Summary description)One, the switch should be 130~150cm away from the ground, 15~20cm away from the frame edge, and cannot be installed behind the door. The position of the wall switch with the wall panel is at least 0.2MI above the top of the board, the height of the exposed socket is not less than 1.3m from the ground, and the installation socket is not less than 0.3m. The kitchen and bathroom are determined separately. Do not install it on the bedside or on the desktop, and the closing direction of all switches must be the same. Second, bathrooms and balconies must be equipped with splash-proof sockets or waterproof boxes. They cannot be installed above bathtubs, faucets, and stoves, and cannot be installed 20cm around the gas meter. Three, household appliances use two-hole sockets rigorously. The power of the Yuba switch is large, and more places are needed. The electrical appliances that often need to be plugged and unplugged can be used with switch sockets. Fourth, calculate the load, the socket without a fixed load is calculated as 1000 watts, and the ordinary socket uses 2.5 square millimeters of copper core wire. 5. Connect the ground wire on the three-hole socket to the neutral wire on the left and the phase wire on the right; the neutral wire on the left and the phase wire on the right of the two-eye socket. Sixth, it must be firmly installed and the joints tightened. Seven, make sure that all wires are fully in contact with the terminal posts of the switch and socket rear seat during installation. Eight, the switch is mostly opened and closed with the opposite hand, the right hand is more than the left hand, usually on the left side of the door, and the door switch should use a fluorescent type. Finally, pay attention to protect the panel of the switch socket during decoration to prevent contamination.